Park / Neutral Position Switch: Installation

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY
1. Install the park/neutral position switch assembly onto the manual transaxle.
2. Provisionally install the 2 bolts.
3. Replace the lock plate with a new one and tighten the manual valve shaft nut.
  Torque: 6.9 N*m (70 kgf*cm, 61 in.*lbf)
  
  Fig 2: Identifying Lock Plate
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Provisionally install the control shaft lever.
5. Turn the lever counterclockwise until it stops, then turn it clockwise 2 notches.
6. Remove the control shaft lever.
7. Align the groove with the neutral basic line.
8. Hold the switch in this position and tighten the 2 bolts.
  Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)
9. Using a screwdriver, stake the nut with the lock plate.
  
  Fig 5: Identifying Staking Nut With Lock Plate
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
10. Install the control shaft lever with the nut and washer.
  Torque: 13 N*m (130 kgf*cm, 9 ft.*lbf)
  
  Fig 6: Identifying Control Shaft Lever With Nut And Washer
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
11. Connect the connector to the park/neutral position switch assembly.
INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY
1. Install the transmission control cable onto the control shaft lever with the nut.
  Torque: 12 N*m (122 kgf*cm, 9 ft.*lbf)
  
  Fig 7: Identifying Nut And Clip
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the transmission control cable into the bracket with the new clip.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)
ADJUST SHIFT LEVER POSITION (See ADJUSTMENT )
INSPECT SHIFT LEVER POSITION (See ON-VEHICLE INSPECTION )
INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY (See ON-VEHICLE INSPECTION )
INSTALL ENGINE UNDER COVER LH