Park / Neutral Position Switch: Adjustment

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

ADJUST PARK/NEUTRAL POSITION SWITCH ASSEMBLY
1. Loosen the bolt of the park/neutral position switch and move the shift lever to the N position.
  
  Fig 1: Identifying Bolt And Park/Neutral Position Switch
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Align the groove with the neutral basic line.
  
  Fig 2: Identifying Groove With Neutral Basic Line
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Hold the switch in position and tighten the 2 bolts.
  Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)
  
  Fig 3: Identifying Bolt And Park/Neutral Position Switch
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. After the adjustment, perform the switch operation check.