Oil Pump: Reassembly

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL CLUTCH DRUM OIL SEAL RING
1. Coat 2 new clutch drum oil seal rings with ATF, and install them onto the stator shaft.
  
  Fig 1: Identifying Clutch Drum Oil Seal Rings
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT OIL PUMP OIL SEAL
1. Using SST, install the front oil pump oil seal into the oil pump body.
  SST 09950-60010 (09951 -00550), 09950-70010 (09951-07100)
  
  Oil seal drive in depth:
  
  -0.15 to 0.15 mm (-0.006 to 0.006 in.)
  
  Fig 2: Identifying Front Oil Pump Oil Seal Into Oil Pump Body
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT OIL PUMP DRIVEN GEAR
1. Coat the front oil pump driven gear with ATF, and install it into the oil pump body with the marked side facing upward.
  
  Fig 3: Identifying Front Oil Pump Driven Gear
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT OIL PUMP DRIVE GEAR
1. Coat the front oil pump drive gear with ATF, and install it into the oil pump body with the marked side facing upward.
  
  Fig 4: Identifying Front Oil Pump Drive Gear
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL STATOR SHAFT ASSEMBLY
1. Using "Torx" socket wrench T30, install the stator shaft assembly with 10 "Torx" screws.
  Torque: 9.8 N*m (100 kgf*cm, 7 ft.*lbf)
  
  Fig 5: Identifying "Torx" Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSPECT OIL PUMP ASSEMBLY
1. Turn the drive gear with 2 screwdrivers and make sure it rotates smoothly.
  NOTE: Do not damage the oil seal lip.
  
  Fig 6: Identifying Drive Gear With 2 Screwdrivers
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT OIL PUMP BODY O-RING
1. Coat a new front oil pump body O-ring with ATF, and install it onto the oil pump.
  
  Fig 7: Identifying Front Oil Pump Body O-Ring
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002