Floor Shift Assembly: Installation

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL FLOOR SHIFT ASSEMBLY
1. Provisionally install the shift lever with the 4 bolts.
  NOTE: Do not jam the wiring of the indicator light or shift lock.
  
  Fig 1: Identifying Shift Lever And Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Tighten the 4 bolts in order, from A to D.
  Torque: 12 N*m (122 kgf*cm, 9 ft.*lbf)
3. Install the shift lock control computer connector and indicator light connector.
CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY
1. Turn the nut of the control cable and push in the lock.
  
  Fig 2: Identifying Turning Nut Of Control Cable
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the control cable onto the shift lever retainer.
  CAUTION:
  - Install the cable with the projection of the cable outer facing upward.
  - After installing, check that the lock of the cable outer is protruding beyond portion A-A, as shown in the illustration.
    
    Fig 3: Identifying Shift Lever Retainer
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Connect the control cable to the shift lever.
Fig 4: Identifying Control Cable
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSPECT SHIFT LEVER POSITION (See ON-VEHICLE INSPECTION )
ADJUST SHIFT LEVER POSITION (See ADJUSTMENT )
INSTALL REAR CONSOLE BOX ASSEMBLY (See INSTALLATION )
INSTALL CONSOLE BOX CARPET (See INSTALLATION )
INSTALL REAR CONSOLE BOX COVER (for Hatchback) (See INSTALLATION )
INSTALL REAR UPPER CONSOLE PANEL SUBASSEMBLY (for Sedan) (See INSTALLATION )
INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY (for Sedan) (See INSTALLATION )
INSTALL CENTER LOWER INSTRUMENT PANEL FINISH PANEL (for Sedan) (See INSTALLATION )
INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY
1. Install the shift lever knob sub-assembly onto the shift lever.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)