LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 237 (Automatic Transmission - U340E) >> Differential Oil Seal >> Removal

Differential Oil Seal: Removal

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.
  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
  2. REMOVE FRONT WHEELS 
  3. REMOVE ENGINE UNDER COVER LH 
  4. REMOVE ENGINE UNDER COVER RH 
  5. DRAIN AUTOMATIC TRANSAXLE FLUID 
    1. Remove the drain plug and gasket, and drain the automatic transaxle fluid.
    2. Install a new gasket and the drain plug.

      Torque: 49 N*m (500 kgf*cm, 36 ft.*lbf) 

  6. REMOVE FRONT AXLE HUB NUT LH  (See REMOVAL )
  7. REMOVE FRONT AXLE HUB NUT RH 

    HINT:

    The removal procedure for the RH side is the same as that for the LH side.

  8. SEPARATE FRONT SPEED SENSOR LH (w/ ABS)  (See REMOVAL )
  9. SEPARATE FRONT SPEED SENSOR RH (w/ ABS) 

    HINT:

    The separation procedure for the RH side is the same as that for the LH side.

  10. SEPARATE FRONT STABILIZER LINK ASSEMBLY LH  (See REMOVAL )
  11. SEPARATE FRONT STABILIZER LINK ASSEMBLY RH 

    HINT:

    The separation procedure for the RH side is the same as that for the LH side.

  12. SEPARATE TIE ROD END SUB-ASSEMBLY LH  (See REMOVAL )
  13. SEPARATE TIE ROD END SUB-ASSEMBLY RH 

    HINT:

    The separation procedure for the RH side is the same as that for the LH side.

  14. SEPARATE FRONT LOWER SUSPENSION ARM LH  (See REMOVAL )
  15. SEPARATE FRONT LOWER SUSPENSION ARM RH 

    HINT:

    The separation procedure for the RH side is the same as that for the LH side.

  16. REMOVE TRANSMISSION CASE PROTECTOR (w/o ABS) 
    1. Remove the 2 bolts and remove the transmission case protector from the automatic transaxle.
    Fig 1: Identifying Bolts And Transmission Case Protector
    G05591060Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  17. REMOVE FRONT DRIVE SHAFT ASSEMBLY LH  (See REMOVAL )
  18. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH  (See REMOVAL )
  19. REMOVE FRONT TRANSAXLE CASE OIL SEAL 
    1. Using SST, remove the front transaxle case oil seal.

      SST 09308-00010 

      Fig 2: Identifying Front Transaxle Case Oil Seal
      G05591061Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  20. REMOVE TRANSAXLE CASE OIL SEAL 
    1. Using SST, remove the transaxle case oil seal.

      SST 09308-00010 

      Fig 3: Identifying Transaxle Case Oil Seal
      G05591062Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002