Typical Enabling Conditions
WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.
The following conditions are common to OFF malfunction and ON malfunction.
TYPICAL ENABLING CONDITIONS
| The monitor runs whenever the following DTCs are not present. | None |
| Time after shifting N to D | 4.5 seconds or more |
| ECT (Engine Coolant Temperature) | 60°C (140°F) or more |
| Transmission shift position | D |
| ECM selected gear | 3rd or 4th |
| Vehicle speed | 15.5 mph (25 km/h) or more |
| Shift solenoid valve S1 circuit | No circuit malfunction |
| Shift solenoid valve S2 circuit | No circuit malfunction |
| Shift solenoid valve SLU circuit | No circuit malfunction |
| ECT sensor circuit | No circuit malfunction |
| Electronic Throttle Control System (if applicable) | No circuit malfunction |
| Speed sensor (NT) circuit | No circuit malfunction |
| Speed sensor (SPD) circuit | No circuit malfunction |
OFF malfunction:
TYPICAL ENABLING CONDITIONS
| ECM lock-up command | ON |
| Duration time from lock-up on command | 3 seconds or more |
| Actual gear | 3rd or 4th |
ON malfunction:
TYPICAL ENABLING CONDITIONS
| ECM lock-up command | OFF |
| Throttle valve opening angle | 8 % or more |
| Vehicle speed | Less than 37.3 mph (60 km/h) |
| Actual gear | 3rd |
| Calculated load value | 22 % or more |