Typical Enabling Conditions
WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.
The following conditions are common to all OFF malfunctions and ON malfunctions.
TYPICAL ENABLING CONDITIONS
| The monitor runs whenever the following DTCs are not present. | P0115 - P0118 (ECT sensor) P0125 (Insufficient ECT for closed loop) P0500 (VSS) P0748 - P0798 (Trans solenoid (range)) |
| ECT (Engine Coolant Temperature) | 60°C (140°F) or more |
| Transmission shift position | D |
| Time after shifting N to D | 4.5 seconds or more |
| Shift solenoid valve S1 circuit | No circuit malfunction |
| Shift solenoid valve S2 circuit | No circuit malfunction |
| ECT sensor circuit | No circuit malfunction |
| Electronic Throttle Control System (if applicable) | No circuit malfunction |
| Speed sensor (NT) circuit | No circuit malfunction |
| Speed sensor (SPD) circuit | No circuit malfunction |
OFF malfunction (a):
TYPICAL ENABLING CONDITIONS
| ECM gearshift command | 1st |
| Vehicle speed | 5.6 mph (9 km/h) or more and less than 24.9 mph (40 km/h) |
| Throttle valve opening angle | 7.0 % or more at engine speed of 1900 rpm (Conditions vary with engine speed) |
OFF malfunction (b);
TYPICAL ENABLING CONDITIONS
| ECM gearshift command | 3rd |
| Vehicle speed | 5.6 mph (9 km/h) or more |
| Throttle valve opening angle | 7.0 % or more at engine speed of 1900 rpm (Conditions vary with engine speed) |
OFF malfunction (c):
TYPICAL ENABLING CONDITIONS
| ECM gearshift command | 4th |
| Vehicle speed | 5.6 mph (9 km/h) or more |
| Throttle valve opening angle | 7.0 % or more at engine speed of 1900 rpm (Conditions vary with engine speed) |
ON malfunction (a):
TYPICAL ENABLING CONDITIONS
| ECM gearshift command | 2nd |
| Vehicle speed | 5.6 mph (9 km/h) or more |
| Throttle valve opening angle | 7.0 % or more at engine speed of 1900 rpm (Conditions vary with engine speed) |
ON malfunction (b):
TYPICAL ENABLING CONDITIONS
| ECM gearshift command | 3rd |
| Vehicle speed | 5.6 mph (9 km/h) or more |
| Throttle valve opening angle | 7.0 % or more at engine speed of 1900 rpm (Conditions vary with engine speed) |
ON malfunction (c):
TYPICAL ENABLING CONDITIONS
| ECM gearshift command | 4th |
| Vehicle speed | 5.6 mph (9 km/h) or more |
| Throttle valve opening angle | 7.0 % or more at engine speed of 1900 rpm (Conditions vary with engine speed) |