Typical Enabling Conditions
WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.
TYPICAL ENABLING CONDITIONS
| The monitor runs whenever the following DTCs are not present. | P0500 (VSS) P0748 - P0798 (Trans solenoid (range)) |
| Shift change | After shift change is completed and before starting next shift change operation |
| ECM selected gear | 3rd or 4th |
| Output shaft rpm | 1000 rpm or more |
| Park/neutral position switch | OFF |
| R switch | OFF |
| L switch | OFF |
| Transmission range switch fail | Not detected |
| Battery voltage | 8 V or more |
| Ignition switch | ON |
| Starter | OFF |
| Engine | Running |