LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 237 (Automatic Transmission - U340E) >> Automatic Transaxle System >> DTC P0711 Transmission Fluid Temperature Sensor "A" Performance >> Typical Enabling Conditions

Typical Enabling Conditions

WARNING: This page is about a different car, the 2008 Toyota Yaris. However, it is still accessible from the selected car via links, so may be relevant.

The following conditions are common to Condition (A) and (B).

TYPICAL ENABLING CONDITIONS

The monitor runs whenever the following DTCs are not present. None
ATF temperature sensor (TFT sensor) circuit No circuit malfunction
ECT (Engine Coolant Temperature) sensor circuit No circuit malfunction
IAT (Intake Air Temperature) sensor circuit No circuit malfunction
Electronic Throttle Control System (if applicable) No circuit malfunction

Condition (A): 

TYPICAL ENABLING CONDITIONS

Time after engine start 18 minutes and 20 seconds or more
Driving distance after engine start 5.6 mile (9 km) or more
Accumulated driving time 3 minutes and 50 seconds or more
ECT -15°C (5°F) or more
IAT (12 seconds after engine start) -10°C (14°F) or more
ECT (12 seconds after engine start) -10°C (14°F) or more

Condition (B): 

TYPICAL ENABLING CONDITIONS

ECT (Current temperature) 60°C (140°F) or more
ECT (12 seconds after engine start) Less than 35°C (95°F)
ATF temperature (12 seconds after engine start) 100°C (212°F) or more