Transmitter Battery: Installation

WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL TRANSMITTER BATTERY
NOTE: Take extra care when handling these precision electronic components.
1. Install a battery (lithium battery: CR2016) with the positive (+) side facing upward, as shown in the illustration.
  NOTE:
  - Be careful not to bend the transmitter battery electrode during insertion.
  - Keep the transmitter cover interior free of dust and oil.
    
    Fig 1: Positions For Installing Battery
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the cover.
  
  Fig 2: Installing Cover
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL DOOR CONTROL TRANSMITTER MODULE

Fig 3: Installing Door Control Transmitter Module
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL TRANSMITTER HOUSING COVER
1. Install the transmitter housing cover to the transmitter housing case.
2. Check that the transmitter's LED illuminates 3 times when the switch is pressed 3 times.
  OK:
  
  Transmitter's LED illuminates 3 times when switch is pressed 3 times.
  
  Fig 4: Installing Transmitter Housing Cover
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002