Inspection Procedure

WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

INSPECT BACK DOOR WITH MOTOR LOCK ASSEMBLY

Apply the battery voltage to the door lock motor and check the operation of the door lock motor.

MEASUREMENT CONDITION AND SPECIFIED CONDITION

Measurement Condition	Specified Condition
Battery positive (+) → 4 (ACT+) Battery negative (-) → 1 (ACT-)	Lock
Battery positive (+) → 1 (ACT-) Battery negative (-) → 4(ACT+)	Unlock

Fig 1: Inspecting Back Door With Motor Lock Assembly

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NG: REPLACE BACK DOOR WITH MOTOR LOCK ASSEMBLY

OK: Go to next step

CHECK WIRE HARNESS (DOOR LOCK - ECU)

Disconnect the Q7 door lock connector.
Disconnect the IH junction block connector.

Fig 2: Identifying Q7 Door Lock And IH Junction Block Connector Terminals
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Measure the resistance of the wire harness side connectors.

Standard resistance

STANDARD RESISTANCE

Tester Connection	Specified Condition
Q7-1 (ACT-) - IH-18 (ACT-)	Below 1 Ω
Q7-4 (ACT+) - IH-17 (ACT+)	Below 1 Ω

NG: REPAIR OR REPLACE HARNESS AND CONNECTOR

OK: REPLACE INSTRUMENT PANEL JUNCTION BLOCK (MAIN BODY ECU)