How To Proceed With Troubleshooting

HINT:

• Use the procedure to troubleshoot the power door lock control system.
• *: Use Techstream.

1. VEHICLE BROUGHT TO WORKSHOP 
2. INSPECT BATTERY VOLTAGE 

   Standard voltage: 

   11 to 14 V 

   If the voltage is below 11V, recharge or replace the battery before proceeding.

3. PROBLEM SYMPTOMS TABLE 

   Result 

   RESULT REFERENCE
   
   

   Result	Proceed to
   Fault is not listed in problem symptoms table	A
   Fault is listed on problem symptoms table	B

   B: Go to step   5

   A: Go to next step 

4. OVERALL ANALYSIS AND TROUBLESHOOTING* 
   1. Operation Check (see OPERATION CHECK  ).
   2. Terminals of ECU (see TERMINALS OF ECU  ).
   3. DATA LIST / ACTIVE TEST (see DATA LIST / ACTIVE TEST  ).
5. ADJUST, REPAIR OR REPLACE 
6. CONFIRMATION TEST 

   END