LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 233 (Brake Control) >> Yaw Rate And Deceleration Sensor >> Removal

Yaw Rate And Deceleration Sensor: Removal

WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
  2. REMOVE FRONT SEAT ASSEMBLY LH 
    1. for Manual Seat:

      Remove the front seat LH (see REMOVAL ).

    2. for Power Seat:

      Remove the front seat LH (see REMOVAL ).

  3. REMOVE FRONT DOOR SCUFF PLATE LH  (See REMOVAL )
  4. REMOVE YAW RATE SENSOR BRACKET 
    1. Remove the bolt and yaw rate sensor bracket.
  5. REMOVE YAW RATE SENSOR ASSEMBLY 
    1. Disconnect the yaw rate sensor connector.
    2. Remove the 2 bolts and yaw rate sensor.
      NOTE: Do not remove the sensor from the bracket.
      Fig 1: Locating Bolts For Yaw Rate Sensor
      G05585122Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals