Inspection Procedure

WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

CHECK TIRE SIZE
1. Check the diameter of all 4 tires.
  OK: Diameter of all 4 tires are equal.
NG: REPLACE TIRES WITH 4 EQUAL SIZE TIRES

OK: Go to next step.
CHECK SPEED SENSOR ROTOR
1. Remove the drive shaft, and check around the speed sensor rotor.
  OK: No scratches or foreign matter on the sensor tip.
NG: REPLACE SPEED SENSOR ROTOR

OK: Go to next step.
CHECK SPEED SENSOR
1. Check the speed sensor circuit (see INSPECTION PROCEDURE or BC-68).
NG: REPLACE SPEED SENSOR

OK: Go to next step.
CHECK WIRE HARNESS (SKID CONTROL ECU - EACH SPEED SENSOR)
1. Check the speed sensor circuit (see INSPECTION PROCEDURE or BC-68).
NG: REPAIR OR REPLACE HARNESS AND CONNECTOR

OK: Go to next step.

RECONFIRM DTC

Clear the DTCs (see DTC CHECK / CLEAR ).
Drive the vehicle at more than 20 km/h (12 mph) for more than 60 seconds.

Check if the same DTCs are detected.

Result

DTC RESULT DESCRIPTION

Result	Proceed to
DTC is output	A
DTC is not output	B

B: END

A: REPLACE ABS AND TRACTION ACTUATOR ASSEMBLY