Inspection Procedure
WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
HINT:
Check that the part numbers of the installed ECM and skid control ECU are correct before performing the following procedure.
- RECONFIRM DTC
- Clear the DTC (see DTC CHECK / CLEAR ).
- Start the engine.
- Check if the same DTC is output (see DTC CHECK / CLEAR
).
Result
DTC RESULT DESCRIPTIONResult Proceed to DTC is output A DTC is not output B
B: END
A: REPLACE ECM