LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 233 (Brake Control) >> Abs And Traction Actuator >> On-Vehicle Inspection

On-Vehicle Inspection

WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
  1. CONNECT TECHSTREAM 
    1. Connect the Techstream to the DLC3.
    2. Start the engine and idle it.
    3. Select the Active Test mode on the Techstream.

      HINT:

      Please refer to the Techstream operator's article for further details.

  2. CHECK ACTUATOR MOTOR OPERATION 
    NOTE: Do not keep a motor relay ON for more than 5 seconds. When operating it consecutively, wait 20 seconds between each operation.
    1. Turn the motor relay ON and check the actuator motor operation noise.
    2. Turn the motor relay OFF.
    3. Fully depress the brake pedal and hold it for approximately 15 seconds. Check that the pedal's initial depth is maintained for the entire 15 seconds.
    4. Turn the motor relay ON and check that the pedal does not pulsate.
    5. Turn the motor relay OFF and release the pedal.
  3. CHECK BRAKE ACTUATOR SOLENOID (for Front Right Wheel) 
    NOTE:
    • Be sure to follow the procedures below when turning ON a solenoid.
    • Do not keep a solenoid ON for more than 10 seconds. When operating it consecutively, wait 20 seconds between each operation.
    • Do not keep a motor relay ON for more than 5 seconds. When operating it consecutively, wait 20 seconds between each operation.
    1. With the pedal depressed as much as possible, perform the following operations.
      1. Turn the SFRH and SFRR solenoids ON simultaneously, and check that the pedal cannot be depressed further.
      2. Turn the SFRH and SFRR solenoids OFF simultaneously, and check that the pedal can be depressed further.
      3. Turn the motor relay ON. Check that the pedal returns to the "depressed as much as possible" position.
    2. Turn the motor relay OFF and release the pedal.
  4. CHECK BRAKE ACTUATOR SOLENOID (for Front Left Wheel) 
    1. Use the same procedures described for the front right wheel to check the solenoids of the front left wheel.

      HINT:

      Front left wheel: SFLH, SFLR

  5. CHECK BRAKE ACTUATOR SOLENOID (for Rear Right Wheel) 
    1. Use the same procedures described for the front right wheel to check the solenoids of the rear right wheel.

      HINT:

      Rear right wheel: SRRH, SRRR

  6. CHECK BRAKE ACTUATOR SOLENOID (for Rear Left Wheel) 
    1. Use the same procedures described for the front right wheel to check the solenoids of the rear left wheel.

      HINT:

      Rear left wheel: SRLH, SRLR

  7. CHECK AND CLEAR DTC 
    1. Check and clear the DTC (see DTC CHECK / CLEAR  ).
scientia non olet · About LEMON Manuals