LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 231 (Differential) >> Active Torque Control 4WD System >> Data List / Active Test

Data List / Active Test

WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
  1. READ DATA LIST 

    HINT:

    Using the Techstream Data List allows switch, sensor and other item values to be read without removing any parts. Reading the Data List early in troubleshooting is one way to save time.

    1. Connect the Techstream to the DLC3.
    2. Turn the ignition switch ON.
    3. Read the Data List according to the display on the tester.

      4WD control ECU 

      DATA LIST

      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      4WD warning lampt 4WD indicator light/OFF or ON OFF: 4WD indicator light
      OFF ON: 4WD indicator light ON      		 -
      Slip Indicator Light Slip indicator light/OFF or ON OFF: SLIP indicator light
      OFF ON: SLIP indicator light ON      		 -
      Stop lamp SW Stop light switch/OFF or ON OFF: Brake pedal released
      ON: Brake pedal depressed      		 -
      Steering angle Steering angle value / Min.: -3276.8 deg
      Max.: 3276.7 deg      		 Min.:-3276.8 deg
      Max.: 3276.7 deg      		 -
      FR wheel SPD FR wheel speed /
      Min.: 0 km/h (0 mph)
      Reading: Max.: 326.4 km/h (202.8 mph)      		 Actual wheel speed Almost no difference from the speedometer
      FL wheel SPD FL wheel speed /
      Min.: 0 km/h (0 mph)
      Reading: Max.: 326.4 km/h (202.8 mph)      		 Actual wheel speed Almost no difference from the speedometer
      RR wheel SPD RR wheel speed /
      Min.: 0 km/h (0 mph)
      Reading: Max.: 326.4 km/h (202.8 mph)      		 Actual wheel speed Almost no difference from the speedometer
      RL wheel SPD RL wheel speed /
      Min.: 0 km/h (0 mph)
      Reading: Max.: 326.4 km/h (202.8 mph)      		 Actual wheel speed Almost no difference from the speedometer
      Ambi temp Ambient temperature /
      Min.: -128°C (198.4°F)
      Max.: 127°C (260.6°F)      		 Min.:-128 (198.4°F)
      Max.: 127 (260.6°F)      		 -
      Coolant temp Engine coolant temperature /
      Min.: 0°C (32°F)
      Max.: 127.5°C (261.5°F)      		 Min.: 0°C(32°F)
      Max.: 127.5°C(261.5°F)      		 -
      Lock SW 4WD lock switch / OFF or ON OFF: 4WD lock switch off
      ON: 4WD lock switch on      		 -
      SLC CUR SLC solenoid (4WD linear solenoid) current /
      Min.: 0 A
      Max.: 3 A      		 Min.: 0 A
      Max.: 3 A      		 -
  2. PERFORM ACTIVE TEST 

    HINT:

    Performing the Techstream Active Test allows switch and other items to be operated without removing any parts. Performing the Active Test early in troubleshooting is one way to save time. The Data List can be displayed during the Active Test.

    1. Connect the Techstream to the DLC3.
    2. Turn the ignition switch ON.
    3. Perform the Active Test according to the display on the tester.

      Combination Meter 

      ACTIVE TEST DETAIL

      Tester Display Test Part Control Range Diagnostic Note
      4WD warn light 4WD indicator light Indicator light is ON / OFF Observe combination meter
      Lock light 4WD lock indicator light Indicator light is ON / OFF Observe combination meter
scientia non olet · About LEMON Manuals