Inspection Procedure

WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

Check the condition of each related circuit connector before troubleshooting (see HOW TO PROCEED WITH TROUBLESHOOTING ).

CHECK FOR DTC

Clear the DTC (see DTC CHECK / CLEAR ).
Turn the ignition switch OFF.

Turn the ignition switch ON and check that can communication system DTC is not output.

Result

RESULT REFERENCE

Result	Proceed to
CAN communication system DTC is output	A
Engine control DTC is output	B

B: GO TO ENGINE CONTROL SYSTEM (2AZ-FE) -- RAV4 or ENGINE CONTROL SYSTEM (2GR-FE) -- RAV4

A: GO TO CAN COMMUNICATION SYSTEM