LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 230 (Automatic Transmission - U241E) >> Park / Neutral Position Switch >> Installation

Park / Neutral Position Switch: Installation

WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY 
    1. Install the switch to the manual valve shaft.
    2. Temporarily install the 2 bolts.
      Fig 1: Identifying Switch Bolts
      G05584155Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Install a new lock washer and tighten the manual valve shaft nut.

      Torque: 6.9 N*m (70 kgf*cm, 61 in.*lbf) 

      Fig 2: Identifying Lock Washer And Manual Valve Shaft Nut
      G05584156Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Temporarily install the control shaft lever.
      5. Fig 3: Identifying Control Shaft Lever
      G05584157Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    5. Turn the lever counterclockwise until it stops, and then turn it clockwise 2 notches.
    6. Remove the control shaft lever.
    7. Align the groove with neutral basic line.
      8. Fig 4: Identifying Groove With Neutral Basic Line
      G05584158Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    8. Hold the switch in this position and tighten the 2 bolts.

      Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf) 

    9. Using a screwdriver, stake the nut with the lock washer.
      Fig 5: Identifying Nut And Lock Plate
      G05584159Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    10. Install the control shaft lever with the washer and nut.

      Torque: 13 N*m (133 kgf*cm, 10 ft.*lbf) 

      Fig 6: Identifying Control Shaft Lever Nut And Washer
      G05584160Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    11. Connect the shift control cable to the control shaft lever with the nut.

      Torque: 15 N*m (153 kgf*cm, 11 ft.*lbf) 

    12. Connect the switch connector.
  2. INSTALL BATTERY 
    1. Install the battery bracket reinforcement with the 2 bolts.

      Torque: 20 N*m (204 kgf*cm, 15 ft.*lbf) 

    2. Install the battery carrier with the 4 bolts.

      Torque: 20 N*m (204 kgf*cm, 15 ft.*lbf) 

    3. Install the battery tray.
    4. Install the battery with the battery clamp.

      Torque: 8.5 N*m (87 kgf*cm, 75 in.*lbf) for bolt 

      5.0 N*m (51 kgf*cm, 44 in.*lbf) for nut 

  3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  4. ADJUST SHIFT LEVER POSITION 
    1. Adjust the shift lever position (see ADJUSTMENT  ).
  5. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY 
    1. Inspect the switch (see ON-VEHICLE INSPECTION  ).
scientia non olet · About LEMON Manuals