Oil Pump: Reassembly

WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL FRONT OIL PUMP OIL SEAL
1. Using SST, install a new oil seal to the pump.
  SST 09350-32014 (09351-32140)
  
  HINT:
  
  The seal end should be flush with the outer edge of the oil pump.
  
  Fig 1: Identifying Oil Seal To Pump
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Coat the lip of the oil seal with petroleum jelly.
INSTALL FRONT OIL PUMP BODY O-RING
1. Coat a new O-ring with ATF, and install it to the oil pump body.
  
  Fig 2: Identifying Front Oil Pump Body O-Ring
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT OIL PUMP DRIVEN GEAR
1. Coat the front oil pump driven gear with ATF, and install it to the oil pump body with the marked side facing up.
  
  Fig 3: Identifying Front Oil Pump Driven Gear
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT OIL PUMP DRIVE GEAR
1. Coat the front oil pump drive gear with ATF, and install it to the oil pump body with the marked side facing up.
  
  Fig 4: Identifying Front Oil Pump Drive Gear
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL STATOR SHAFT ASSEMBLY
1. Set stator shaft by aligning each bolt hole.
2. Using a T30 "TORX" socket, install the 11 bolts.
  Torque: 9.8 N*m (100 kgf*cm, 87 in.*lbf)
INSTALL CLUTCH DRUM OIL SEAL RING
NOTE: Do not expand the ring ends excessively.
1. Install the 2 clutch drum oil seal rings.
INSPECT OIL PUMP ASSEMBLY (See INSPECTION )