LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 229 (Automatic Transmission - U151F) >> Automatic Transaxle System >> DTC P0985 Shift Solenoid "E" Control Circuit Low (Shift Solenoid Valve SR); DTC P0986 Shift Solenoid "E" Control Circuit High (Shift Solenoid Valve SR) >> Typical Enabling Conditions

Typical Enabling Conditions

WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

P0985: Range check (Low resistance): 

TYPICAL ENABLING CONDITIONS

The monitor will run whenever this DTC is not present. None
Shift solenoid valve SR ON
Battery voltage 8 V or more
Ignition switch ON
Starter OFF

P0986: Range check (High resistance): 

TYPICAL ENABLING CONDITIONS

The monitor will run whenever this DTC is not present. None
Shift solenoid valve SR OFF
Battery voltage 8 V or more
Ignition switch ON
Starter OFF