Inspection Procedure

WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

DTC P2610 is set if an internal ECM problem is detected. Diagnostic procedures are not required. ECM replacement is necessary.
Read freeze frame data using Techstream. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data from the time the malfunction occurred.

REPLACE ECM
1. Replace the ECM (see REMOVAL ).
CHECK WHETHER DTC OUTPUT RECURS
1. Connect Techstream to the DLC3.
2. Turn the ignition switch ON.
3. Turn the tester ON.
4. Clear DTCs (see DTC CHECK / CLEAR ).
5. Start the engine and wait for 10 minutes or more.
6. On the tester, select the following menu items: Powertrain / Engine and ECT / Trouble Code.
7. If no pending DTC is displayed, the repair has been successfully completed.
NEXT: END