LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 227 (Engine Control System (2AZ-FE)) >> SFI System >> DTC P2119 Throttle Actuator Control Throttle Body Range/ Performance >> Inspection Procedure

Inspection Procedure

WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

Read freeze frame data using Techstream. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data from the time the malfunction occurred.

  1. CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P2119) 
    1. Connect Techstream to the DLC3.
    2. Turn the ignition switch ON.
    3. Turn the tester ON.
    4. Select the following menu items: Powertrain / Engine and ECT / Trouble Code.
    5. Read DTCs.

      Result 

      RESULT REFERENCE

      Display (DTC Output) Proceed To
      P2119 A
      P2119 and other DTCs B

      HINT:

      If any DTCs other than P2119 are output, troubleshoot those DTCs first.

    B:  GO TO DTC CHART 

    A: Go to Next Step 

  2. CHECK WHETHER DTC OUTPUT RECURS (DTC P2119) 
    1. Connect Techstream to the DLC3.
    2. Turn the ignition switch ON.
    3. Turn the tester ON.
    4. Clear DTCs (see DTC CHECK / CLEAR  ).
    5. Allow the engine to idle for 15 seconds.
      CAUTION: Exercise extreme care and take precautions in steps (f) and ( g) below. Failure to do so may result in the vehicle unexpectedly rolling away.
    6. Securely apply the parking brake and move the gear selector lever to the D position.
    7. While depressing the brake pedal securely, fully depress the accelerator pedal for 5 seconds.
    8. On the tester, select the following menu items: Powertrain / Engine and ECT / Trouble Code.
    9. Read DTCs.

      HINT:

      The output voltage of the throttle position sensor can be checked during step ( g) using Techstream. Variations in the output voltage indicate that the throttle actuator is in operation. To check the output voltage using Techstream, select the following menu items: Powertrain / Engine and ECT / Data List / ETCS / Throttle Position No. 1 and Throttle Position No. 2.

      OK: No DTC output. 

    NG: REPLACE THROTTLE BODY ASSEMBLY 

    OK: CHECK FOR INTERMITTENT PROBLEMS 

scientia non olet · About LEMON Manuals