Inspection Procedure

HINT:

Read freeze frame data using Techstream. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data from the time the malfunction occurred.

1. CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P2111 OR P2112) 
   1. Connect Techstream to the DLC3.
   2. Turn the ignition switch ON.
   3. Turn the tester ON.
   4. Select the following menu items: Powertrain / Engine and ECT / Trouble Code.
   5. Read DTCs.

      Result 

      RESULT REFERENCE
      
      

      Display (DTC Output)	Proceed To
      P2111 or P2112	A
      P2111 or P2112 and other DTCs	B

      HINT:

      If any DTCs other than P2111 or P2112 are output, troubleshoot those DTCs first.

   B:  GO TO DTC CHART 

   A: Go to Next Step 

2. INSPECT THROTTLE BODY ASSEMBLY (VISUALLY CHECK THROTTLE VALVE) 
   1. Check for contamination between the throttle valve and the housing. If necessary, clean the throttle body. And check that the throttle valve moves smoothly.

      OK: Throttle valve is not contaminated with foreign objects and moves smoothly. 

   NG: REPLACE THROTTLE BODY ASSEMBLY 

   OK: Go to Next Step 

3. CHECK WHETHER DTC OUTPUT RECURS (DTC P2111 OR P2112) 
   1. Connect Techstream to the DLC3.
   2. Turn the ignition switch ON.
   3. Turn the tester ON.
   4. Clear DTCs (see DTC CHECK / CLEAR  ).
   5. Start the engine, and fully depress and release the accelerator pedal quickly (to fully open and close the throttle valve).
   6. Select the following menu items: Powertrain / Engine and ECT / Trouble Code.
   7. Read DTCs.

      Result 

      RESULT REFERENCE
      
      

      Display (DTC Output)	Proceed To
      No DTC	A
      P2111 or P2112	B

   B: REPLACE ECM 

   A: CHECK FOR INTERMITTENT PROBLEMS