Inspection Procedure

WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

READ CURRENT DTC

Connect Techstream to the DLC3.
Turn the ignition switch ON and turn the tester ON.
Select the following menu items: Powertrain / Engine and ECT / Trouble Code.

Read DTCs.

Result

RESULT REFERENCE

Display (DTC Output)	Proceed To
P0630	A
P0630 and other DTCs	B

If any DTCs other than P0630 are output, troubleshoot those DTCs first.

NOTE: If P0630 is set, the VIN must be input to the ECM using Techstream. However, all DTCs are cleared automatically by the tester when the VIN is input. If DTCs other than P0630 are set, check them first.

B: GO TO DTC CHART

A: Go to Next Step

INPUT VIN WITH TECHSTREAM
1. Refer to the REGISTRATION .
NEXT: END