Typical Enabling Conditions
WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
All:
TYPICAL ENABLING CONDITIONS
| Monitor runs whenever following DTCs not present | None |
Case 1:
TYPICAL ENABLING CONDITIONS
| Time after starter OFF to ON | 3 seconds or more |
| Number of CMP sensor signal pulse | 6 times |
| Battery voltage | 7 V or more |
| CMP sensor circuit failure | Not detected |
| Ignition switch | ON |
Case 2:
TYPICAL ENABLING CONDITIONS
| Starter | OFF |
| Engine speed | 600 rpm or more |
| Time after starter from ON to OFF | 3 seconds or more |