LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 227 (Engine Control System (2AZ-FE)) >> Ignition Relay No. 2 >> On-Vehicle Inspection

On-Vehicle Inspection

WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
  2. REMOVE IG2 RELAY 
    1. Remove the No. 1 engine room relay block cover.
    2. Remove the IG2 relay from the engine room relay block.
  3. INSPECT IG2 RELAY 
    1. Measure the resistance of the IG2 relay.

      Standard resistance 

      RESISTANCE SPECIFICATION

      Tester Connection Specified Condition
      3 - 5 10 kΩ or higher
      3 - 5 Below 1 Ω
      (when battery voltage is applied to terminals 1 and 2)
      Fig 1: Identifying Ignition Relay No 2 Terminals
      G05183858Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      If the result is not as specified, replace the relay.

  4. INSTALL IG2 RELAY 
  5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
scientia non olet · About LEMON Manuals