LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 227 (Engine Control System (2AZ-FE)) >> Engine Coolant Temperature Sensor >> Removal

Engine Coolant Temperature Sensor: Removal

WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
  1. DRAIN ENGINE COOLANT  (See REPLACEMENT )
  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
  3. REMOVE AIR CLEANER CAP  (See REMOVAL  )
  4. REMOVE AIR CLEANER CASE  (See REMOVAL  )
  5. REMOVE ENGINE COOLANT TEMPERATURE SENSOR 
    1. Disconnect the sensor connector.
    2. Using SST, remove the sensor and gasket. SST 09817-33190
scientia non olet · About LEMON Manuals