Valve Body Assembly: Installation

1. Install the 5 shift solenoid valves with the 5 bolts and 4 plates.

   Torque: 6.6 N*m (67 kgf*cm, 58 in.*lbf) for bolt A 

   11 N*m (112 kgf*cm, 8 ft.*lbf) for bolt B 

   HINT:

   Each bolt length is indicated below.

   Bolt length: 

   12 mm (0.47 in.) for Bolt A 

   45 mm (1.77 in.) for Bolt B 

   Fig 1: Identifying Shift Solenoid Valves With Bolts And Plates

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the spring and check ball body.
   Fig 2: Identifying Spring And Check Ball Body

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Align the groove of the manual valve with the pin of lever.
4. Install the 17 bolts.

   Torque: 11 N*m (112 kgf*cm, 8 ft.*lbf) 

   NOTE:

   • Push the valve body against the accumulator piston spring and the check ball body to install it.
   • Tighten the bolts marked by * in the illustration first temporarily because they are positioning bolts.

   HINT:

   Each bolt length is indicated below.

   Fig 3: Identifying Bolts

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Bolt length: 

   25 mm (0.984 in.) for Bolt A 

   41 mm (1.614 in.) for Bolt B 

   45 mm (1.771 in.) for Bolt C 

1. Coat the O-ring of the temperature sensor with ATF.
2. Install the ATF temperature sensor with the lock plate and bolt.

   Torque: 6.6 N*m (67 kgf*cm, 58 in.*lbf) 

   Fig 4: Identifying ATF Temperature Sensor With Lock Plate And Bolt

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Connect the 5 shift solenoid valve connectors.

1. Coat a new O-ring with ATF.
2. Install the O-ring to the oil strainer.
   Fig 5: Identifying Oil Strainer O-Ring

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Install the oil strainer with the 3 bolts.

   Torque: 11 N*m (112 kgf*cm, 8 ft.*lbf) 

   Fig 6: Locating Oil Strainer Bolts

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Install the 3 magnets in the oil pan.
   Fig 7: Identifying Magnets In Oil Pan

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install a new gasket and oil pan with the 18 bolts.

   Torque: 7.6 N*m (77 kgf*cm, 67 in.*lbf) 

   Fig 8: Locating Oil Pan Bolts

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Fluid type: 

Toyota Genuine ATF WS or Equivalent 

1. Inspect the fluid level (see AUTOMATIC TRANSAXLE FLUID  ).

1. Perform the RESET MEMORY procedures (A/T initialization) (see INITIALIZATION  ).