LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 226 (Automatic Transmission - U140F) >> Transmission Oil Cooler >> Installation

Transmission Oil Cooler: Installation

WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL TRANSMISSION OIL COOLER 
    1. Install the oil cooler to the bracket with the 3 bolts.

      Torque: 12 N*m (122 kgf*cm, 9 ft.*lbf) 

      Fig 1: Locating Transmission Oil Cooler Bolts
      G05582320Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. *1: Connect the No. 1 oil cooler outlet hose to the transmission.
      3. Fig 2: Locating Transmission Oil Cooler
      G05582322Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. *2: Connect the No. 1 oil cooler inlet hose to the transmission.
    4. *3: Connect the No. 3 water by-pass hose to the transmission.
    5. *4: Connect the No. 4 water by-pass hose to the transmission.
  2. ADD AUTOMATIC TRANSAXLE FLUID 
  3. INSPECT AUTOMATIC TRANSAXLE FLUID 
    1. Inspect the automatic transaxle fluid (see AUTOMATIC TRANSAXLE FLUID  ).
  4. ADD COOLANT 
    1. Add the coolant (see REPLACEMENT ).
scientia non olet · About LEMON Manuals