LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 226 (Automatic Transmission - U140F) >> Speed Sensor >> Removal

Speed Sensor: Removal

WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
  2. REMOVE BATTERY 
    1. Loosen the nut and remove the bolt and battery clamp.
    2. Remove the battery.
    3. Remove the battery tray.
    4. Remove the 4 bolts and battery carrier.
    5. Remove the 2 bolts and battery bracket reinforcement.
  3. REMOVE SPEED SENSOR NT 
    1. Disconnect the sensor connector.
    2. Remove the bolt and sensor.
      3. Fig 1: Locating Speed Sensor Bolt (NT)
      G05582262Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Remove the O-ring from the sensor.
  4. REMOVE SPEED SENSOR NC 
    1. Disconnect the sensor connector.
    2. Remove the bolt and sensor.
      3. Fig 2: Locating Speed Sensor Bolt (NC)
      G05582263Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Remove the O-ring from the sensor.
scientia non olet · About LEMON Manuals