LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 226 (Automatic Transmission - U140F) >> Park / Neutral Position Switch >> Installation

Park / Neutral Position Switch: Installation

WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY 
    1. Install the switch to the manual valve shaft.
    2. Temporarily install the 2 bolts.
      Fig 1: Locating Switch Bolts
      G05388037Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Install a new lock plate and tighten the manual valve shaft nut.

      Torque: 6.9 N*m (70 kgf*cm, 61 in.*lbf) 

    4. Temporarily install the control shaft lever.
      Fig 2: Identifying Control Shaft Lever
      G05388040Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    5. Turn the lever counterclockwise until it stops, and then turn it clockwise 2 notches.
    6. Remove the control shaft lever.
      Fig 3: Identifying Control Shaft Lever
      G05582278Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    7. Align the groove with neutral basic line.
      8. Fig 4: Locating Groove With Neutral Basic Line
      G05388042Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    8. Hold the switch in this position and tighten the 2 bolts.

      Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf) 

    9. Using a screwdriver, stake the nut with the lock plate.
      Fig 5: Identifying Nut With Lock Plate
      G05388036Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    10. Install the control shaft lever with the washer and nut.

      Torque: 13 N*m (133 kgf*cm, 10 ft.*lbf) 

      Fig 6: Locating Control Shaft Lever With Washer And Nut
      G05388035Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    11. Connect the shift control cable to the control shaft lever with the nut.

      Torque: 15 N*m (153 kgf*cm, 11 ft.*lbf) 

    12. Connect the switch connector.
  2. INSTALL BATTERY 
    1. Install the battery bracket reinforcement with the 2 bolts.

      Torque: 20 N*m (204 kgf*cm, 15 ft.*lbf) 

    2. Install the battery carrier with the 4 bolts.

      Torque: 20 N*m (204 kgf*cm, 15 ft.*lbf) 

    3. Install the battery tray.
    4. Install the battery with the battery clamp.
  3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  4. ADJUST SHIFT LEVER POSITION 
    1. Adjust the shift lever position (see ADJUSTMENT  ).
  5. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY 
    1. Inspect the switch (see ON-VEHICLE INSPECTION  ).
scientia non olet · About LEMON Manuals