Oil Pump: Reassembly

WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL FRONT OIL PUMP OIL SEAL
1. Using SST and a hammer, install a new oil seal to the pump.
  SST 09350-32014 (09351-32140)
  
  HINT:
  
  The seal end should be flat with the outer edge of the oil pump.
  
  Fig 1: Identifying New Oil Seal To Pump
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Coat the lip of the oil seal with petroleum jelly.
INSTALL FRONT OIL PUMP BODY O-RING
1. Coat the new O-ring with ATF, and install it to the oil pump body.
  
  Fig 2: Identifying Front Oil Pump Body O-Ring
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT OIL PUMP DRIVEN GEAR
1. Coat the front oil pump driven gear with ATF, and install it to the oil pump body with the marked side facing up.
  
  Fig 3: Identifying Mark On Front Oil Pump Driven Gear
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT OIL PUMP DRIVE GEAR
1. Coat the front oil pump drive gear with ATF, and install it to the oil pump body with the marked side facing up.
  
  Fig 4: Identifying Mark On Front Oil Pump Drive Gear
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL STATOR SHAFT ASSEMBLY
1. Set the stator shaft by aligning each bolt hole.
2. Using a T30 "TORX" socket, install the 11 bolts.
  Torque: 9.8 N*m (100 kgf*cm, 87 in.*lbf)
  
  Fig 5: Identifying Stator Shaft Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL CLUTCH DRUM OIL SEAL RING
1. Install the 2 clutch drum oil seal rings.
  NOTE: Do not expand the ring ends excessively.
  
  Fig 6: Identifying Clutch Drum Oil Seal Rings
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSPECT OIL PUMP ASSEMBLY (See INSPECTION )