Forward Clutch: Disassembly

WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

INSPECT FORWARD CLUTCH (See INSPECTION )
REMOVE FORWARD MULTIPLE DISC CLUTCH DISC
1. Using a screwdriver, remove the snap ring.
  
  Fig 1: Identifying Snap Ring
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Remove the flange, 5 discs and 5 plates from the input shaft.
Fig 2: Identifying Flange, Discs And Plates From Input Shaft
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSPECT FORWARD MULTIPLE DISC CLUTCH DISC (See INSPECTION )
REMOVE FORWARD CLUTCH RETURN SPRING SUB-ASSEMBLY
1. Place SST on the spring retainer and compress the return spring with a press.
  SST 09350-32014(09351-32070)
2. Using a snap ring expander, remove the snap ring.
  
  Fig 3: Identifying Snap Ring
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Remove the piston return spring.
Fig 4: Identifying Piston Return Spring
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSPECT FORWARD CLUTCH RETURN SPRING SUB-ASSEMBLY (See INSPECTION )
REMOVE FORWARD CLUTCH PISTON SUBASSEMBLY
1. Place the forward clutch drum onto the oil pump.
2. Holding the forward clutch piston with your hand, apply compressed air (392 kPa, 4.0 kgf/cm² , 57 psi) to the oil pump to remove the forward clutch piston.
  HINT:
  
  When the piston is slanted and cannot be removed, remove it by pushing down the protruding side and applying compressed air again, or using needle-nose pliers (with its tips wrapped in tape).
  
  Fig 5: Identifying Compressed Air To Oil Pump
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Using a screwdriver, pry out the 2 O-rings.
Fig 6: Identifying Prying Out O-Rings
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE FORWARD CLUTCH PISTON SUBASSEMBLY (See DISASSEMBLY )
REMOVE INPUT SHAFT OIL SEAL RING

Fig 7: Identifying Input Shaft Oil Seal Ring
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002