LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 226 (Automatic Transmission - U140F) >> Automatic Transaxle System >> DTC P0741 Torque Converter Clutch Solenoid Performance (Shift Solenoid Valve DSL) >> Typical Malfunction Thresholds

Typical Malfunction Thresholds

WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

Either of the following conditions is met: OFF malfunction or ON malfunction

OFF malfunction 

TYPICAL MALFUNCTION THRESHOLDS

Engine speed - input (turbine) speed 100 rpm or more

ON malfunction 

2 detections are necessary per driving cycle:

1st detection: temporary flag ON

2nd detection: pending fault code ON

Vehicle speed must be under 10 km/h (6.2 mph) once before 2nd detection

TYPICAL MALFUNCTION THRESHOLDS

Difference between engine speed and input (turbine) speed Less than 35 rpm