LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 226 (Automatic Transmission - U140F) >> Automatic Transaxle System >> DTC P0741 Torque Converter Clutch Solenoid Performance (Shift Solenoid Valve DSL) >> Typical Enabling Conditions

Typical Enabling Conditions

WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

All 

TYPICAL ENABLING CONDITIONS

The monitor will run when ever this DTC is no present P0115-P0118: ECT sensor
P0125: Insufficient ECT for Closed Loop
P0500: VSS
P0748-P0799: Trans solenoid (range)
Transmission range "D"
ECT (Engine coolant temperature) 60°C (140°F) or higher
ATF temperature -20°C (-4°F) or higher
ATF temperature sensor circuit Not circuit malfunction
ECT sensor circuit Not circuit malfunction
Turbine speed sensor circuit Not circuit malfunction
Intermediate shaft speed sensor circuit Not circuit malfunction
Output speed sensor circuit Not circuit malfunction
Shift solenoid valve SL1 circuit Not circuit malfunction
Shift solenoid valve SL2 circuit Not circuit malfunction
Shift solenoid valve S4 circuit Not circuit malfunction
Shift solenoid valve DSL circuit Not circuit malfunction
Electronic throttle system Not circuit malfunction

OFF malfunction 

TYPICAL ENABLING CONDITIONS

ECM lock-up command ON
ECM selected gear 3rd or 4th
Vehicle speed 25 km/h (15.5 mph) or more

ON malfunction 

TYPICAL ENABLING CONDITIONS

ECM lock-up command OFF
ECM selected gear 3rd or 4th
Vehicle speed 25 to 60 km/h (15.5 to 37.2 mph)
Throttle valve opening angle 8% or more