DTC P0705 Transmission Range Sensor Circuit Malfunction (PRNDL Input): Description
WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
The Park/Neutral Position (PNP) switch detects the shift lever position and sends signals to the ECM.
DTC DETECTION CONDITION AND TROUBLE AREA REFERENCE
| DTC No. |
DTC Detection Condition |
Trouble Area |
| P0705 |
When one of following conditions is met:
- Any 2 or more of the following signals are ON simultaneously (2 trip detection logic)
- P input signal is ON
- N input signal is ON
- R input signal is ON
- D input signal is ON
- 3 input signal is ON
- 2 input signal is ON
- Any 2 or more of the following signals are ON simultaneously (2 trip detection logic)
- NSW input signal is ON
- R input signal is ON
- D input signal is ON
- 3 input signal is ON
- 2 input signal is ON
- All of the signals are OFF simultaneously (2 trip detection logic)
- P input signal is OFF
- N input signal is OFF
- NSW input signal is OFF
- R input signal is OFF
- D input signal is OFF
- 3 input signal is OFF
- 2 input signal is OFF
- Both 1 and 2 are met (2 trip detection logic)
- Either of the following is met
- NSW input signal is ON
- P input signal is ON
- N input signal is ON
- R input signal is ON
- Either of the following is met
- 4 input signal is ON
- L input signal is ON
|
- Open or short in park/neutral position switch circuit
- Park/Neutral position switch
- ECM
|