Blower Unit: Disassembly

WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

REMOVE HEATER TO REGISTER DUCT ASSEMBLY
1. Detach the 7 claws and register duct.
  
  Fig 1: Identifying Claws And Register Duct
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE AIR FILTER CASE
1. Detach the 2 claws and remove the air filter case.
2. Remove the air filter.
  
  Fig 2: Identifying Claws And Air Filter Case
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE AIR INLET CONTROL SERVO MOTOR (for Manual Air Conditioning System)
1. Remove the 3 screws and air inlet servo motor.
  
  Fig 3: Identifying Air Inlet Servo Motor And Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE AIR INLET CONTROL SERVO MOTOR (for Automatic Air Conditioning System)
1. Detach the claws and lever.
  
  Fig 4: Detaching Claws And Lever
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Remove the 3 screws and air inlet servo motor.
  
  Fig 5: Identifying Air Inlet Servo Motor And Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE BLOWER RESISTOR (for Manual Air Conditioning System)
1. Remove the 2 screws and blower resistor.
  
  Fig 6: Locating Screws And Blower Resistor
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE BLOWER MOTOR
1. Remove the 3 screws and blower motor.
  
  Fig 7: Locating Screws And Blower Motor
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002