AIR CONDITIONING PANEL (for Manual Air Conditioning System): Removal

WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTE: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL CENTER (See REMOVAL )
REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL CENTER (See REMOVAL )
REMOVE RADIO RECEIVER ASSEMBLY (See REMOVAL )
REMOVE AIR CONDITIONING CONTROL ASSEMBLY
1. Remove the 2 screws.
2. Using a screwdriver, detach the 3 clips.
  HINT:
  
  Tape the screwdriver tip before use.
3. Disconnect the connectors and remove the air conditioning control.
  
  Fig 1: Identifying Air Conditioning Control Assembly And Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE AIR MIX CONTROL SWITCH
1. Detach the 2 claws and remove the air mix control switch.
  
  Fig 2: Removing Air Mix Control Switch
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE BLOWER CONTROL SWITCH
1. Detach the 2 claws and remove the blower control switch.
  
  Fig 3: Removing Blower Control Switch
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE AIR VENT MODE CONTROL SWITCH
1. Detach the 2 claws and remove the mode control switch.
  
  Fig 4: Removing Air Vent Mode Control Switch
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002