LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 225 (Air Conditioning) >> AIR CONDITIONING PANEL (for Automatic Air Conditioning System) >> Removal

AIR CONDITIONING PANEL (for Automatic Air Conditioning System): Removal

WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    NOTE: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
  2. REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL CENTER  (See REMOVAL )
  3. REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL CENTER  (See REMOVAL )
  4. REMOVE RADIO RECEIVER  (See REMOVAL )
  5. REMOVE AIR CONDITIONING CONTROL ASSEMBLY 
    1. Remove the 2 screws.
    2. Using a screwdriver, detach the 3 clips.

      HINT:

      Tape the screwdriver tip before use.

    3. Connect the connectors and remove the air conditioning control.
      Fig 1: Identifying Air Conditioning Control Assembly And Screws
      G05585475Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals