Transmission Wire: Installation

WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL TRANSMISSION WIRE
1. Coat a new O-ring of the transmission wire connector with ATF.
2. Install the O-ring to the transmission wire connector.
  
  Fig 1: Identifying 0-Ring From Transmission Wire Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Install the transmission wire.
4. Install the bolt.
5. Connect the connector.
6. Coat the O-ring of the ATF temperature sensor with ATF.
7. Apply ATF to the bolt.
8. Install the ATF temperature sensor with the lock plate and bolt.
  Torque: 6.6 N*m (67 kgf*cm, 58 in.*lbf)
  
  Fig 3: Identifying Lock Plate And ATF Temperature Sensor
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
9. Connect the 7 shift solenoid valve connectors.
INSTALL AUTOMATIC TRANSAXLE OIL PAN SUBASSEMBLY
1. Install the 2 magnets in the oil pan.
  
  Fig 4: Identifying Magnets In Oil Pan
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install a new gasket and the oil pan with the 18 bolts.
  Torque: 7.6 N*m (80 kgf*cm, 69 in.*lbf)
  
  Fig 5: Identifying Oil Pan Gasket With Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL NO. 1 ENGINE UNDER COVER
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
ADD AUTOMATIC TRANSAXLE FLUID
Fluid type:

Toyota Genuine ATF WS or Equivalent
INSPECT TRANSAXLE FLUID LEVEL
1. Inspect the fluid level (see ON-VEHICLE INSPECTION ).