Oil Pump: Reassembly

WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL FRONT OIL PUMP OIL SEAL
1. Using SST and a hammer, tap in a new oil seal to the oil pump body.
  SST 09350-32014 (09351-32140)
  
  HINT:
  
  The seal end should be flat with the outer edge of the oil pump.
  
  Fig 1: Identifying Tapping Oil Seal To Oil Pump Body
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Coat the lip of the oil seal with MP grease.
INSTALL FRONT OIL PUMP BODY O-RING

Fig 2: Identifying Front Oil Pump Body O-Ring
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
1. Coat a new O-ring with ATF, and install it to the oil pump body.
  NOTE:
  - Make sure that the O-ring is not twisted or pinched.
  - Apply enough ATF to the O-ring before installation.
INSTALL FRONT OIL PUMP DRIVEN GEAR
1. Coat the front oil pump driven gear with ATF, and install it to the oil pump body with the marked side facing upward.
  
  Fig 3: Identifying Oil Pump Body With Marked Side Facing Upward
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT OIL PUMP DRIVE GEAR
1. Coat the front oil pump drive gear with ATF, and install it to the oil pump body with the marked side facing upward.
  
  Fig 4: Identifying Oil Pump Body With Marked Side Facing Upward
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL STATOR SHAFT ASSEMBLY
1. Set the stator shaft and align it with each bolt hole.
2. Using a T30 "TORX" socket, install the 11 bolts.
  Torque: 9.8 N*m (100 kgf*cm, 87 in.*lbf)
  
  Fig 5: Identifying Stator Shaft Assembly Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL CLUTCH DRUM OIL SEAL RING
1. Coat 2 new oil seal rings with ATF.
2. Install 2 new clutch drum oil seal rings.
  NOTE: Do not expand the ring ends excessively.
INSPECT OIL PUMP ASSEMBLY (See INSPECTION )