Typical Enabling Conditions
WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
P2769: Range check (Low resistance)
P2769: RANGE CHECK (LOW RESISTANCE)
| The monitor will run whenever this DTC is not present | None |
|---|---|
| Shift solenoid valve DSL | ON |
| Solenoid current cut status | Not cut |
| Battery voltage | 8 V or more |
| Starter | OFF |
| Ignition switch | ON |
P2770: Range check (High resistance)
P2770: RANGE CHECK (HIGH RESISTANCE)
| The monitor will run whenever this DTC is not present | None |
|---|---|
| Shift solenoid valve DSL | ON |
| Battery voltage | 8 V or more |
| Starter | OFF |
| Ignition switch | ON |