Inspection Procedure

WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

INSPECT TRANSMISSION WIRE (SHIFT SOLENOID VALVE DSL)

Disconnect the B32 wire connector.

Fig 1: Identifying B32 Wire Connector

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Measure the resistance of the transmission wire.

Standard resistance

TESTER CONNECTION SPECIFIED CONDITION CHART

Tester Connection	Condition	Specified Condition
10 (DSL) - Body ground	20°C (68°F)	11 to 13 Ω

NG: Go to step 3

OK: Go to next step

CHECK WIRE HARNESS (TRANSMISSION WIRE - ECM)

Disconnect the B30 ECM connector.

Fig 2: Identifying B30 ECM Connector

Measure the resistance of the wire harness side connector.

Standard resistance

TESTER CONNECTION SPECIFIED CONDITION CHART

Tester Connection	Condition	Specified Condition
B30-9 (DSL) - Body ground	20°C (68°F)	11 to 13 Ω

NG: REPAIR OR REPLACE HARNESS AND CONNECTOR

OK: REPLACE ECM

INSPECT SHIFT SOLENOID VALVE DSL
1. Remove the shift solenoid valve DSL.
2. Measure the resistance between the solenoid valve terminal and solenoid valve body.
  Standard resistance:
  
  11 to 13 Ω at 20°C (68°F)
3. Connect the battery's positive (+) lead to the terminal of the solenoid valve connector, and the negative (-) lead to the solenoid body. Then Check that the valve moves and makes an operating noise.
  OK:
  
  Valve moves and makes operating noise.
NG: REPLACE SHIFT SOLENOID VALVE DSL

OK: REPAIR OR REPLACE TRANSMISSION WIRE