Inspection Procedure

WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

INSPECT TRANSMISSION WIRE (SHIFT SOLENOID VALVE SL3)

Disconnect the B32 wire connector.

Fig 1: Identifying B32 Wire Connector

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Measure the resistance of the transmission wire.

Standard resistance

TESTER CONNECTION SPECIFIED CONDITION CHART

Tester Connection	Condition	Specified Condition
4 (SL3+) - 11 (SL3-)	20°C (68°F)	5.0 to 5.6 Ω
4 (SL3+) - Body ground	20°C (68°F)	10 kΩ or higher
11 (SL3-) - Body ground	20°C (68°F)	10 kΩ or higher

NG: Go to step 3

OK: Go to next step

CHECK WIRE HARNESS (TRANSMISSION WIRE - ECM)

Disconnect the B30 ECM connector.

Fig 2: Identifying B30 ECM Connector

Measure the resistance of the wire harness side connector.

Standard resistance

TESTER CONNECTION SPECIFIED CONDITION CHART

Tester Connection	Condition	Specified Condition
B30-14 (SL3+) - B30-15 (SL3-)	20°C (68°F)	5.0 to 5.6 Ω
B30-14 (SL3+) - Body ground	20°C (68°F)	10 kΩ or higher
B30-1S (SL3-) - Body ground	20°C (68°F)	10 kΩ or higher

NG: REPAIR OR REPLACE HARNESS AND CONNECTOR

OK: REPLACE ECM

INSPECT SHIFT SOLENOID VALVE SL3
1. Remove the shift solenoid valve SL3.
2. Measure the resistance of the solenoid valve.
  Standard resistance:
  
  5.0 to 5.6 Ω at 20°C (68°F)
3. Connect the battery's positive (+) lead with a 21 W bulb to terminal 2 and the negative (-) lead to terminal 1 of the solenoid valve connector. Then check that the valve moves and makes an operating noise.
  OK:
  
  Valve moves and makes operating noise.
NG: REPLACE SHIFT SOLENOID VALVE SL3

OK: REPAIR OR REPLACE TRANSMISSION WIRE