LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 224 (Automatic Transmission - U151E) >> Automatic Transaxle System >> DTC P0776 Pressure Control Solenoid "B" Performance (Shift Solenoid Valve SL2) >> Typical Enabling Conditions

Typical Enabling Conditions

WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

All: 

TYPICAL ENABLING CONDITIONS CHART - ALL

The monitor will run whenever these DTCs are not present. P0115 - P0118 (ECT sensor)
P0125 (Insufficient ECT for closed loop)
P0500 (VSS)
P0748, P0778, P0798 (Shift solenoid valve (range))
ECT (Engine coolant temperature) 10°C (50°F) or more
Transmission range "D"
ATF temperature -20°C (-4°F) or more
ATF temperature sensor circuit Not circuit malfunction
ECT sensor circuit Not circuit malfunction
Turbine speed sensor circuit Not circuit malfunction
Intermediate shaft speed sensor circuit Not circuit malfunction
Output speed sensor circuit Not circuit malfunction
Shift solenoid valve SL1 circuit Not circuit malfunction
Shift solenoid valve SL2 circuit Not circuit malfunction
Shift solenoid valve SL3 circuit Not circuit malfunction
Shift solenoid valve S4 circuit Not circuit malfunction
Shift solenoid valve SR circuit Not circuit malfunction
Shift solenoid valve DSL circuit Not circuit malfunction
Electronic throttle system Not circuit malfunction

OFF malfunction (A): 

TYPICAL ENABLING CONDITIONS CHART - OFF MALFUNCTION (A)

ECM lock-up command OFF
Vehicle speed Less than 60 km/h (37.3 mph)
Throttle valve opening angle 7% or more

OFF malfunction (B): 

TYPICAL ENABLING CONDITIONS CHART - OFF MALFUNCTION (B)

ECM selected gear 1st
Vehicle speed Less than 40 km/h (24.9 mph)
Throttle valve opening angle 4.5% or more at engine speed 1,900 rpm (Varies with engine speed)

OFF malfunction (C): 

TYPICAL ENABLING CONDITIONS CHART - OFF MALFUNCTION (C)

ECM selected gear 3rd
Throttle valve opening angle 4.5% or more at engine speed 1,900 rpm (Varies with engine speed)

OFF malfunction (D): 

TYPICAL ENABLING CONDITIONS CHART - OFF MALFUNCTION (D)

Duration time from shift command of ECM 15 sec. or more
ECM selected gear 4th or 5th

ON malfunction (A): 

TYPICAL ENABLING CONDITIONS CHART - ON MALFUNCTION (A)

ECM selected gear 1st
Vehicle speed Less than 40 km/h (24.9 mph)
Throttle valve opening angle 4.5% or more at engine speed 1,900 rpm (Varies with engine speed)

ON malfunction (B): 

TYPICAL ENABLING CONDITIONS CHART - ON MALFUNCTION (B)

ECM selected gear 3rd
Throttle valve opening angle 5.0% or more at output speed 1,400 rpm (Varies with engine speed)
Malfunction of pressure control solenoid "B" (SL2) and "C" (SL3) Not detected

ON malfunction (C): 

TYPICAL ENABLING CONDITIONS CHART - ON MALFUNCTION (C)

Throttle valve opening angle 7.0% or more at output speed 1,050 rpm (Varies with engine speed)
Malfunction of pressure control solenoid "B" (SL2) Not detected