Typical Enabling Conditions
WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
TYPICAL ENABLING CONDITIONS CHART
| The monitor will run whenever these DTCs are not present. | P0500 (VSS) P0748 - P0798 (Trans solenoid (Range)) |
|---|---|
| Shift change | Shift change is completed before starting next shift change operation |
| ECM selected gear | 2nd, 3rd, 4th or 5th |
| Output shaft rpm | 1,000 rpm or more |
| NSW switch | OFF |
| R switch | OFF |
| L switch | OFF |
| Engine | Running |
| Ignition switch | ON |
| Starter | OFF |