LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 223 (Engine Control System (2GR-FE)) >> SFI System >> DTC P0300 Random / Multiple Cylinder Misfire Detected; DTC P0301 Cylinder 1 Misfire Detected; DTC P0302 Cylinder 2 Misfire Detected; DTC P0303 Cylinder 3 Misfire Detected; DTC P0304 Cylinder 4 Misfire Detected; DTC P0305 Cylinder 5 Misfire Detected; DTC P0306 Cylinder 6 Misfire Detected >> Typical Enabling Conditions

Typical Enabling Conditions

WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

Misfire: 

TYPICAL ENABLING CONDITIONS CHART - MISFIRE

Monitor runs whenever following DTCs not present P0102 - P0103 (Mass air flow meter)
P0110 - P0113 (Intake air temperature sensor)
P0115 - P0118 (Engine coolant temperature sensor)
P0120 - P0223, P2135 (Throttle position sensor)
P0125 (Insufficient engine coolant temperature for Closed Loop)
P0327, P0328 (Knock sensor)
P0335 (Crankshaft position sensor)
P0340 (VVT sensor)
P0500 (VSS)
Battery voltage 8 V or more
VVT system Not operated by scan tool
Engine RPM 450 to 6500 rpm
Either of following conditions (a) or (b) met -
(a) Engine coolant temperature at engine start More than-7°C (19°F)
(b) Engine coolant temperature More than 20°C (68°F)
Fuel cut OFF

Monitor period of emission-related-misfire: 

MONITOR PERIOD OF EMISSION-RELATED-MISFIRE

First 1000 revolutions after engine start, or Check Mode Crankshaft 1000 revolutions
Except above Crankshaft 1000 revolutions x 4

Monitor period of catalyst-damaged-misfire (MIL blinks): 

MONITOR PERIOD OF CATALYST-DAMAGED-MISFIRE (MIL BLINKS)

All of following conditions 1, 2 and 3 met Crankshaft 200 revolutions x 3
1. Driving cycles 1st
2. Check mode OFF
3. Engine RPM Less than 2600 rpm
Except above Crankshaft 200 revolutions
scientia non olet · About LEMON Manuals