LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 223 (Engine Control System (2GR-FE)) >> Crankshaft Position Sensor >> Inspection

Crankshaft Position Sensor: Inspection

WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT CRANKSHAFT POSITION SENSOR 
    1. Measure the resistance between the terminals.

      Standard resistance 

      TEMPERATURE SPECIFIED CONDITION CHART

      Temperature Specified Condition
      Cold 1, 630 to 2, 740 Ω
      Hot 2, 065 to 3, 225 Ω
      Fig 1: Identifying Crankshaft Position Sensor Connector Terminals
      G05184268Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      NOTE: In the table above, the terms "Cold" and "Hot" refer to the temperature of the coils. "Cold" means approximately -10 to 50°C (14 to 122°F). "Hot" means approximately 50 to 100°C (122 to 212°F).

      If the resistance is not as specified, replace the sensor.

scientia non olet · About LEMON Manuals