LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 223 (Engine Control System (2GR-FE)) >> Camshaft Timing Oil Control Valve Assembly >> On-Vehicle Inspection

On-Vehicle Inspection

WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY 
    1. Check the operation.
      1. Connect the Techstream to the DLC3.
      2. Turn the ignition switch to ON.
      3. Turn the Techstream main switch ON.
      4. Start and warm up the engine.
      5. Enter the following menus: Powertrain / Engine and ECT / Active Test.
      6. Operate the oil control valve using the Techstream, and then check the engine speed.

        Standard condition 

        RESULT CHART

        Condition Specified Condition
        Oil control valve is OFF Normal engine speed
        Oil control valve is ON Rough idling or engine stalls

        If the operation is not as specified, check the oil control valve, wire harness and ECM.

scientia non olet · About LEMON Manuals